Wexiodisk WD-7 DUPLUS Installation And User Manual page 40

Instructions for use
Changing the water
For the best washing results, it is important to change the water in the washing
tank often. For normally soiled loads, the washing water should be changed after
around 30 washes. Always change the water in the event of foam problems in the
tank.
If IF09 appears on the display, this indicates that the water should be changed.
When the machine is in P0 mode with the hood open and the symbol (2) is lit,
change the water as follows:
Machines without a drain pump
•
•
•
•
•
•
•
Machines with a drain pump
•
•
•
•
•
•
•
•
WD-7 DUPLUS
Check that the machine is in P0 mode.
Open the hood. On machines with automatic hood lift, the hood is opened/
closed with the button (5).
Remove the tank filter and cover plates (21).
Empty the machine by turning the level pipe (19) clockwise.
When the tank is empty, the level pipe (19) is turned clockwise. The tank
filter and cover plates (21) are refitted.
Check that the final rinse symbol (2) is lit.
Close the hood and the machine will refill.
Check that the machine is in P0 mode.
Open the hood. On machines with automatic hood lift, the hood is opened/
closed with the button (5).
Remove the tank filter and cover plates (21) and the level pipe (19).
Press the 0/1 button (9), emptying starts automatically.
When the tanks are empty, refit the level pipe (19), tank filters and cover
plates (21).
Press the 0/1 button (9).
Check that the final rinse symbol (2) is lit.
Close the hood and the machine will refill.
36
Rev. (201403)