Exiting The Autopan Menu; Setting Up A Mimic Tour; Selecting A Mimic Tour; Recording A Mimic Tour - Honeywell HDZ30A User Manual

Exiting the Autopan Menu

Exit the AUTOPAN setup menu and go back to the MAIN PAGE 2 to carry on setup of the
camera.

Setting Up a Mimic Tour

A Mimic Tour is a route formulated by manual operation of the HDZ Series Analogue PTZ Dome.
The user runs through a path by adjusting pan, tilt and zoom parameters, which will be stored
by the camera and can be recalled to execute at any time.

Selecting a Mimic Tour

Up to 16 sets of Mimic Tours can be created for an HDZ Series camera. Use the joystick or
LEFT/RIGHT direction keys to select a Mimic Tour to program. Follow the steps in
Mimic Tour, page

Recording a Mimic Tour

Follow the procedure below to record the Mimic Tour path:
1.
2.
Figure 4-21 Mimic Tour Menu
MIMIC TOUR
MIMIC TOUR NO.
RECORD START
RECORD END
RUN CRUISE
DELETE
EXIT
71, to start programming a Mimic Tour route.
Navigate to the MIMIC TOUR menu (see
program (see Selecting a Mimic Tour, page
press IRIS+, then move the PTZ camera to the starting point for the tour and press IRIS+
again.
Note For some protocols, users may need to move the camera to the desired Mimic
Tour starting point before entering the OSD menus.
Use the joystick on the control device to start building the tour route. The percentage of
the memory buffer used will be displayed on the screen.
Note Beware of the memory size percentage when building a Mimic Tour route. Once
the buffer percentage reaches 100%, recording of the tour will stop.
Operation and Configuration | 71
01 →
PT MOVE ↓
PT MOVE
↓
ENTER ↓
ENTER ↓
YES
Figure 4-21), select the MIMIC TOUR NO to
71), move the cursor to RECORD START and
Recording a
800-16526 - A - 07/2014