Setting The Motion Frame; Figure 4-27 Frame Set Menu - Honeywell HDZ30A User Manual

Setting the Motion Frame

In a monitored field, users can define specific areas as motion detection target zones. Up to four
frames can be set as motion detection target zones. Please refer to the instructions as follows
to configure parameters for each motion detection zone, called a Frame. When motion is
detected within a defined frame, a flash warning notice, MOTION, will display in the upper left
corner of the screen. A set frame is independent of the pan/tilt/zoom coordinates (unlike privacy
masks).
A total of four frames can be set. Select a frame using the right/left keys on the keyboard, and
press the IRIS+ key to enter the frame's submenu, as shown in
Figure 4-27 Frame Set Menu
FRAME SET 1
LEFT LIMIT
TOP LIMIT
H SIZE
V SIZE
MODE
PRESET POINT
DWELL TIME
EXIT
LEFT LIMIT
Move the frame right/left using the joystick or right/left keys on the keyboard.
TOP LIMIT
Shift the frame up/down using the joystick or right/left keys on the keyboard.
H/V SIZE
Adjust the frame size by changing the H SIZE/V SIZE value using the right/left keys on the
keyboard.
MODE
Assign a trigger action for a motion detection frame. Options include PRESET, PRESET TOUR,
AUTOPAN and MIMIC TOUR. When motion is detected within a frame, the HDZ Series Dome
Camera will execute the specific trigger action that has been assigned.
Note After the user has selected the mode as one of PRESET, PRESET TOUR,
AUTOPAN and MIMIC TOUR, the user will need to specify the specific Preset,
Preset Tour, Autopan or Mimic Tour number to execute when triggered.
Operation and Configuration | 79
L/R
D/U
-/+
-/+
PRESET →
001 →
ALWAYS →
YES
Figure 4-27, below.
800-16526 - A - 07/2014