Deleting A Preset Tour; Exiting The Preset Tour Menu; Setting Up An Autopan Path; Selecting An Autopan Line - Honeywell HDZ30A User Manual

Deleting a Preset Tour

Users can command the HDZ Series Analogue PTZ Dome to delete the selected Preset Tour.
Move the cursor to DELETE and press the IRIS+ key (ENTER) to delete the selected Preset
Tour (see
Preset Tour to be deleted).

Exiting the Preset Tour Menu

Select the EXIT item to exit the PRESET TOUR menu and go back to the MAIN PAGE 2 to carry
on setup of the HDZ Series camera.

Setting Up an Autopan Path

An Autopan is the motion of scanning an area horizontally, panning back and forth between a
start and end point so that the Analogue PTZ Dome can monitor a horizontal view. The
parameters are listed in the following sections.

Selecting an Autopan Line

There are four sets of Autopan lines built in to the HDZ Series Analogue PTZ Dome. Users can
choose an Autopan line to execute by pressing LEFT/RIGHT direction keys or using the joystick
(see

Setting the Autopan Start and End Points

Follow the procedure below to set the starting position of the AUTOPAN path:
1.
2.
3.
Selecting the Preset Tour Number on page 67
Figure 4-19 Autopan Menu
AUTOPAN
AUTOPAN LINE
START POINT
END POINT
DIRECTION
SPEED
RUN AUTOPAN
DELETE
EXIT
Figure 4-19).
Move the cursor to START POINT and press IRIS+ while PT MOVE is flashing. The item
will automatically change to display TO SAVE.
Move the dome to a desired starting position using the PTZ controls and press IRIS+ to
save the position as the starting point. The cursor will automatically move to the END
POINT line. The end point must be set to complete the autopan programming.
Move the dome to a desired ending position using the PTZ controls and press IRIS+ to
save the position as the ending point.
Operation and Configuration | 69
for more information on selecting the
1
→
PT MOVE ↓
PT MOVE ↓
RIGHT →
01 →
ENTER ↓
ENTER ↓
YES
800-16526 - A - 07/2014