Sharpness Control (Menu => Camera =>Shapeness); Digital Zoom (Menu => Camera =>Digital Zoom); Night Shot Menu (Menu => Camera =>Night Shot) - Honeywell ScanDome III HSDC-252 Series Operation & Programming Manual

OUTPUT
MOTION AREA SET : User can configure motion detection area. Area selection
3.4.6 SHARPNESS CONTROL (MENU => CAMERA =>SHAPENESS)
The higher, the more enhanced edges in the picture. (0 ~ 15).
3.4.7 DIGITAL ZOOM (MENU => CAMERA =>DIGITAL ZOOM)
OFF - Optical zoom only
2x, 4x, 8x, Max. - Digitally magnifies up to 2x, 4x, 8x, 16x respectively.
3.4.8 NIGHT SHOT MENU (MENU => CAMERA =>NIGHT SHOT)
The NIGHT SHOT option removes the IR Cut filter of the camera and makes the camera
sensitive to near infrared.
If NIGHT SHOT mode of the selected camera is set to Manual, 10+ ON will enable the NIGHT
SHOT mode, 10+ OFF will turn off the NIGHT SHOT mode.
MODE : MANUAL / AUTO
User can decide sensitivity of motion detection
: OFF / R01 / R02 .
method is same to BMB area selection
Digital Zoom Setup
MAX
PIP
Position
Exit
Night Shot Setup
Mode
Local Control
Exit
AUTO – Camera automatically goes into B&W mode at low light.
MANUAL - Manually controls the Night Shot mode in LOCAL
CONTROL option. On/Off Night Shot mode remotely by pressing 10+
ON/ 10+ OFF.
: MAX
: ON
: R.TOP
: MANUAL
: OFF
32