Assembling the Camera
Camera assembly is quick and easy. To assemble the camera:
1.
2.
3.
4.
5.
6.
7.
Take the camera and all other components out of the packaging.
Rotate and remove the protective cover bag from the camera body.
Use the torx driver to remove the dome cover.
Remove the foam and tape from inside the dome.
Remove the lens cap from the camera lens.
Use the torx driver to fasten the dome cover to the camera body.
Note
Optional: Use the lubricant on the dome cover's rubber ring to make it easier to
re-attach to the housing and seal the PTZ dome cover and housing without water
coming in. Be careful not to get any lubricant on the dome as it may interfere with
viewing PTZ images.
Leave the protective film on the dome cover until installation is complete.
Installing the Camera | 23
800-16526 - A - 07/2014