Setting The Preset Position; Setting The Preset Tour Speed; Setting The Preset Tour Dwell Time; Running A Preset Tour - Honeywell HDZ30A User Manual

68 | HDZ Series Analogue PTZ User Manual

Setting the Preset Position

Users can assign a specific preset position to the selected Preset Number with this item (see
Figure
END. END is the selection used for the Preset Position following the last Preset Position you
want programmed when the amount of preset numbers will be less than 32 (see
Preset Number on page

Setting the Preset Tour Speed

Users can set the pan/tilt speed of the HDZ Series Analogue PTZ Dome Camera from the
selected Preset Position to the next point in the tour. Users can set speeds that range from 1
(slowest) to 15 (fastest). Within this range, the PAN speed varies from 10 to 400 (degrees/sec.),
and the TILT speed varies from 8 to 400 (degrees/sec.).

Setting the Preset Tour Dwell Time

The DWELL TIME is the duration of time that the Analogue PTZ Dome will stay at the Preset
Position. The available dwell time range is from 000 to 127 seconds. The HDZ Series Camera
will go to the next Preset Position after the dwell time expires. If the dwell time is set to 000, the
HDZ Series Camera will stay at the current position for less than 1 second and then move to the
next position.

Running a Preset Tour

Users can command the HDZ Series Analogue PTZ Dome to run the selected Preset Tour
manually. Select the PRESET TOUR NO to run, move the cursor to RUN PRE TOUR and press
the IRIS+ key (ENTER) to execute the selected Preset Tour (see
Number on page 67
www.honeywell.com/security
4-18). Use the joystick or LEFT/RIGHT direction keys to select a preset from 1~255 or
67).
Note If you are not using all 32 Preset Numbers in the tour, please set the point
following the last required Preset Number as END (for PRESET POSITION) so
that the preset tour can function properly. For example, if a user intends to set a
Preset Tour with 5 Preset Positions, it is required to set the PRESET POSITION
of Preset Number 06 as END.
for more information).
Note Users can also execute the Preset Tour function through a keyboard/controller.
Please refer to the keyboard's documentation for more information about
executing PTZ commands.
Selecting a
Selecting the Preset Tour