Installing A Ceiling Mount (Indoor Only); Figure 2-10 Hdcm1 Ceiling Mount Installation - Honeywell HDZ30A User Manual

32 | HDZ Series Analogue PTZ User Manual

Installing a Ceiling Mount (Indoor Only)

The HDCM1 ceiling mount weighs 4.0 lb. (1.8 kg) and can be installed directly to a load-bearing
ceiling. The mount has a maximum load rating of 26.0 lb. (11.7 kg) and is for indoor use only.
See the documentation included with the ceiling mount for more information on securing the
mount to the mounting surface.
To install a ceiling mount:
1. Ensure that the ceiling can support the combined
weight of the camera and the mount (should
support at least 8.8 lb. [4.0 kg]).
2. Make a cable entry hole in the ceiling.
3. Feed the cables through the mount, leaving
approximately 1 ft (0.3 m) extending past the end
of the mount (see
Note If you are using the recommended safety cable
for additional security, feed it through the
mount and attach one end to the camera eyelet
and the other end to the building structure (see
Figure 2-9).
4. Attach the mount to the ceiling using appropriate
hardware.
5. Feed the cables through the indoor mount kit and
screw the indoor mount kit onto the ceiling
mount.
6. Connect the cables to the camera (see
Switches and Cable Connections on page
Connect the video output port either to a coaxial
cable (with BNC connection) or with optional UTP
balun accessory if unshielded twisted pair
cabling is used.
Note Check that the eyelet safety cable connection is
secure, and carrying all of the load of the
camera after making all cable connections.
7. Attach the camera to the mount kit and then
tightly fix the security screw on the top of the
camera.
www.honeywell.com/security
Figure 2-10 HDCM1 Ceiling Mount Installation
Figure 2-10).
Dip
Feed
cables
through the
mount kit
25).
Example of
Indoor Dome
Ceiling Mount
Installation
Screw the
mount kit into
the ceiling
mount
Attach the
camera
body to
the mount
kit
Tightly fix the
screw at the top of
the camera