Setting The Dwell Time; Setting The Alarm Priority - Honeywell HDZ30A User Manual

Selecting a Preset Tour
PRESET TOUR (P. TOUR) must be selected as the ALARM ACTION for this option to be
available (see Selecting the Alarm Action on page
PTZ Dome should execute when the selected alarm is triggered. The preset tour(s) should be
defined in the Preset Tour setup menu or through the keyboard prior to using with the Alarm
function (see Setting Up a Preset Tour on page
Selecting an Autopan Line
AUTOPAN must be selected as the ALARM ACTION for this option to be available (see
Selecting the Alarm Action on page
PTZ Dome should execute when the selected alarm is triggered. The autopan path(s) should be
defined in the Autopan setup menu or through the keyboard prior to using the Alarm function
(see Setting Up an Autopan Path on page 69
Selecting a Mimic Tour
MIMIC TOUR (M. TOUR) must be selected as the ALARM ACTION for this option to be
available (see Selecting the Alarm Action on page
Analogue PTZ Dome should execute when the selected alarm is triggered. The mimic tour(s)
should be defined in the Mimic Tour setup menu or through the keyboard prior to using the
Alarm function (see Setting Up a Mimic Tour on page 71
mimic tour).

Setting the Dwell Time

The DWELL TIME is the duration to be applied when executing the alarm action. If the PRESET
mode is selected, the HDZ Series Analogue PTZ Dome will go to the selected preset position
and stay there for a user-defined period of time (1~127 seconds/Always) when alarm takes
place, or until the alarm condition is released or users rotate the joystick to change the status of
the Dome Camera.
If other modes (PRESET TOUR/AUTOPAN/MIMIC TOUR) have been selected, the camera will
keep executing the selected mode (DWELL TIME is set to ALWAYS and cannot be changed)
until the alarm condition is released or users rotate the joystick to change the status of the Dome
Camera.
Note The dwell time is only adjustable when PRESET is selected as the alarm action.
When the dwell time is up, the HDZ Series Dome Camera will go back to its
trigger position and recheck the alarm pin status.

Setting the Alarm Priority

Set the alarm priority from 1 to 4 for each alarm pin. If two or more alarms are triggered at the
same time, smaller alarm priority number will have higher priority of being handled. The default
alarm priority is 1 for Alarm Pin 1, 2 for Alarm Pin 2, and so on.
Operation and Configuration | 77
76). Select a preset tour that the Analogue
67).
76). Select a autopan path that the HDZ Series Analogue
for more information on setting up autopan paths).
76). Select a mimic tour that the HDZ Series
for more information on setting up a
800-16526 - A - 07/2014