Refitting The Complete Front Wheel - APRILIA RS 125 Manual

CHASSIS
7.5.5.

REFITTING THE COMPLETE FRONT WHEEL

Read 1.2.1 carefully.
TORQUE WRENCH SETTINGS
Caliper mounting bolts (7)
Wheel spindle bolt (6)
Wheel spindle clamp screws (8)
• Smear a light coat of grease over the total length of
the wheel spindle (1); see
WARNING
Use great care when refitting the wheel to
avoid damaging the brake lines, brake discs
and brake pads.
•
Position the housing (3) of the speedometer drive (2)
correctly to the special anti-rotation peg (4).
NOTE The spacer (5) must have the larger diameter face
pointing to the right fork leg.
•
Position the spacer (5) to the wheel.
•
Place the wheel between the fork legs above the
support.
DANGER
Do not attempt to align the holes by putting
your fingers into the holes. This could result
in severe personal injury.
•
Move the wheel until the centre hole aligns with the
holes in the forks.
•
Slide the wheel spindle (1) fully home.
•
Fit the washer and snug the screw (6) hand-tight.
•
Lock out wheel spindle (1) rotation.
•
Tighten the screw (6) fully.
WARNING
Use great care or you might damage the brake
pads.
•
Fit the brake caliper to the brake disc with the
mounting holes aligned with the holes in the caliper
carrier.
WARNING
Replace both caliper mounting bolts (7) with
new bolts of the same type fitted originally.
7 - 66
22 Nm (2.2 kgm).
80 Nm (8 kgm).
12 Nm (1.2 kgm)
1.8.1.
3
4
2
5
RS 125
1
7
6