Operator Interface Hardware - Oce Arizona 6160 XTS User Manual

Operator Interface Hardware

Operator Interface Hardware
Introduction
The Operator interacts with printer components to print, maintain, and monitor the state of the
printer. This section identifies and explains the functions of the hardware.
[12] Printer Hardware
Operator Interface Components
Hardware Interface Components
Component
1) Main Power Switch
2) Emergency Stops
3) Carriage
4) Static Suppression Sys-
tem
5) Registration Pins
6) UV Lamps
7) Vacuum Gauges
8) Print Button
9) Automatic Maintenance
Station
46 Chapter 3 ‐ How to Navigate the User Interface
Function
Turns the printer On and Off.
Emergency stop buttons can shut down all motion and hazardous
systems. There are four E-stops, one on each end of the carriage,
and one on each side of the gantry (long red strip).
Contains the printheads and ink reservoirs and protects the Opera-
tor from exposure to UV light.
Reduces static charge on the media and results in less artifacts
from dust and debris that affect print quality.
The registration pins are activated manually by the operator and
allow quick registration of the media.
UV light is used to cure the ink.
Display the strength of the table vacuum system. If it reads less
than 10"Hg, check for vacuum leaks.
Starts the current print job.
Automatically cleans the printheads and provides access to clean
the underside of the carriage.
4
Océ Arizona 6100 Series