Uv Ink And Flush - Oce Arizona 6160 XTS User Manual

UV Ink and Flush

Introduction
General Safety Information
You can find the power-marking label near the mains entrance. If connection to a different mains
voltage is required, contact Customer Service.
Do not remove caution labels or caution notations. If a label or notation is soiled, please clean the
label or notation. If you cannot make label or notation legible, or if the label or notation is
damaged, please contact your service representative.
The required operating space of this product is located in the Site Preparation Document.
Please refer to the corresponding Safety Data Sheets or the Site Preparation Guide for specific
safety information, including the dimensions of the product, the recommended room volume and
ventilation rate. You can download the Safety Data Sheets from the support site of your product
at http://global.oce.com/support/.
UV Ink and Flush
Introduction
The safety concerns involved with the handling and use of the UV ink and Flush are detailed in
the Material Safety Data Sheet (MSDS) documents. Review them before handling any UV ink or
flush.
NOTE
The MSDS for all UV inks and Flush are available from the corporate Océ Global E-Marketing
(GEM) website. For the latest MSDS and PSDS, visit: http://global.oce.com/support/
CAUTION
UV inks can be harmful if not properly handled. Follow the MSDS guidelines carefully in order
to ensure maximum safety.
Personal Safety
The operator must wear nitrile gloves, a protective apron, and safety glasses with side shields
when handling inks. Read and practice safety guidelines as outlined in the MSDS for each ink.
Post these documents in the work area as required by prevailing law. MSDS are provided with all
inks and flush when you purchase them.
Print Height Warning
Avoid printing at a height greater than recommended as this causes excessive emissions of UV
light and ink mist. Always measure the thickness of the media in use and set the carriage height
correctly for that media.
Disposal of UV Ink
All waste containing uncured or partly cured UV ink is hazardous and must be disposed of
separately according to local regulations. Do not mix ink waste with non-hazardous waste
(household, office, etc). Do not allow it to reach sewage systems or drinking water supplies. Ink
waste includes maintenance pads and cloths, gloves and any other material containing uncured
or partly cured UV ink. Disposal must be made according to official local regulations.
16 Chapter 2 ‐ Safety Information
Océ Arizona 6100 Series