How To Clean The Gantry Rails - Oce Arizona 6160 XTS User Manual

How to Clean the Gantry Rails

Introduction
Dust and debris can accumulate on the gantry rails, which run along the length of the table. The
bearings that run on the rails are equipped with shields that are designed to keep debris from
entering the bearing housing. After a period of time and use, debris can accumulate on the
outside of the bearing shields as the gantry travels along the table.
When to do
Inspect and clean the rails and bearings at least once a month. If you notice any dirt or ink on the
gantry rails, or an accumulation of debris on the rails bearings, clean them immediately.
Required tools
Poly-Wipe lint-free Cloth (Hint: you can also use a swab to clear away the dust)
IMPORTANT
In the event of an ink spill on the rail, it should be cleaned immediately. Slight ink stains that
remain on the rail after cleaning are not a major problem.
CAUTION
Because of the possibility of gantry movement it is best to clean the rails with power off.
Procedure
1. Power OFF the printer at the AC power On/Off switch.
2. Turn the switch to the horizontal Lockout position and apply a lock.
3. Use a dry lint-free cloth to remove all visible debris that has accumulated next to the bearing
shields. It is only necessary to clean the outside bearing shields. When removing debris always
wipe away from the shields.
4. Remove the lock from the Lockout switch.
5. Power ON the printer.
Océ Arizona 6100 Series
How to Clean the Gantry Rails
Chapter 10 ‐ Printer Maintenance 167