How To Power On - Oce Arizona 6160 XTS User Manual

How to Power ON

Introduction
This section describes how to switch the printer On and Off. When the printer is switched On, the
interface software is displayed on the LCD monitor that is located on the Operator Control Station.
From there the operator can access and control the printer. We recommend that you leave the
printer powered on at all times. However, if the printer is switched Off for extended periods, there
are procedures to follow that are documented here.
Before you begin
Before you apply AC power to the printer, make sure that loose objects such as clothing, tools and
cleaning materials are not interfering with the printer mechanisms. Position the power cord so that
it does not pose a hazard when walking around or moving media or other objects near the printer.
The printer has an AC power switch that turns the printer On or Off. The switch also
functions as an AC power lock-out switch. It is located at the end of the printer, as seen below.
CAUTION
THE SOCKET OUTLET MUST BE INSTALLED NEAR THE EQUIPMENT AND BE EASILY
ACCESSIBLE. Ensure that you follow the guidelines in the Site Preparation Guide before
plugging the printer AC power plug into the socket.
IMPORTANT
Unplug the AC power cord from the printer to completely isolate the electronics of the printer,
especially when you move or service the printer.
Procedure
1. Ensure that the AC power plug is properly seated.
2.
Turn on the AC power On/Off switch.
3.
If it is not already on, turn on the power of the Control Station LCD monitor.
4.
During the boot-up procedure, the printer software is automatically started. The software displays
a splash screen.
5.
The splash screen will show initialization messages and then the Print Job Control screen
appears. The initialization is complete when the top left panel of the display shows "Ready". Your
printer is now ready for use.
Océ Arizona 6100 Series
Chapter 4 ‐ How to Operate Your Océ Arizona Printer
How to Power ON
69