Oce Arizona 6160 XTS User Manual page 161

3. Hold the wire attached to the left end of the lamp in one hand and use a finger of the other hand
to reach under the ceramic end to ease the bulb out of the retainer clip. Perform the same action
to release the other end of the bulb.
Note the orientation of the ceramic end in the retainer clip so that you can put the new lamp in
the same spot. The clip clamps to the small diameter ceramic section at the end of the bulb.
4.
Place the used bulb in a container for recycling as per your local regulations.
5.
Clean the lamp shutter with a lint-free cloth (do not use water, although alcohol can be used if
needed).
6.
Prior to installing the new UV lamp bulb, use the cleaning wipes provided in the replacement kit
to remove and dust or debris from the glass bulb .
7. Pick up the new bulb by its ceramic ends and insert the bulb into the retainer clips one at a time,
ensuring that the bulb is centered and seated firmly into the clips at both ends.
8. Reconnect the bulb power connectors at both ends.
Océ Arizona 6100 Series
How to Change a UV Lamp Bulb
Chapter 10 ‐ Printer Maintenance 161