Oce Arizona 6160 XTS User Manual page 171

[67] Ink bleed tube valve
5.
Turn the bleed tube valve shutoff lever so that it is parallel to the bleed tube to open the valve
and release any pressure, then flip the shutoff lever back to the perpendicular closed position
after about 30 seconds.
NOTE
The ink system is under pressure and so it is possible that some ink may spray out at first. Keep
the cloth wrapped around the end of the bleed tube so that any ink spay is contained.
6.
Pull the target ink filter out of its metal retainer clip.
7.
Unscrew the bleed tube cap from the old filter and thread it into the top connector of the new
filter. Place the cap that came with the new filter on the old filter to prevent ink from leaking out
of the old filter.
8.
Repeat the previous step for the top and bottom connections.
NOTE
Wipe off any spilled ink.
9.
Insert the new filter into the empty retainer clip and make sure the flow arrow on the filter points
downward. Be careful not to pinch the ink lines.
10.
Proceed to How to Bleed an Ink Filter (necessary to remove air from a new filter).
Océ Arizona 6100 Series
How to Change an Ink Filter
Chapter 10 ‐ Printer Maintenance 171