Matrox MXO2 Installation And User Manual page 121

¦ Note Adobe Premiere Pro will automatically render sections that have a red
render bar when you start an export to tape, but to avoid having dropped frames
you must render both the red and yellow sections before performing a Matrox
export to tape.
Make sure that you've properly connected your RS-422 recorder and
4
configured Matrox device control as explained in
control" on page 99.
¦ Note
When exporting to tape, Matrox uses a preroll of five seconds. This
value is hardcoded and cannot be changed. The Preroll and Timecode Offset
options available in Premiere Pro are ignored when using Matrox device
control for exporting to tape.
Load a striped recordable tape into your recorder, and set your recorder to
5
Remote or VTR mode.
Make sure that the sequence is activated, and then choose File > Export >
6
Tape to open the Matrox Export to Tape panel.
"Setting up Matrox device
Working with Adobe Premiere Pro
103