Toshiba e-STUDIO520 Service Manual page 55

Symbol Name
M25 REV-FAN-MOT2
Reverse section cooling
fan-2
M26 IH-FAN-MOT
IH board cooling fan
M27 DCT-O-FAN-MOT
Duct out fan
M28 FUS-FAN-MOT
Fuser cooling fan
M29 EXIT-FAN-MOT
Exit section cooling fan
M30 DCT-I-FAN-MOT
Duct in fan
M31 DEV-FAN-MOT
Developer unit fan
M32 LSU-FAN-MOT
Laser unit cooling fan
M33 SYS-FAN-MOT
SYS board cooling fan
M34 PS-FAN-MOT1
Switching regulator cool-
ing fan-1
M35 PS-FAN-MOT2
Switching regulator cool-
ing fan-2
M36 DF-READ-MOT
Read motor
M37 DF-FEED-MOT
Document feed motor
M38 DF-TRY-MOT
Tray lift motor
M39 DF-L-EXIT-MOT
Large original exit motor
M40 DF-S-EXIT-MOT
Small original exit motor
M41 LCF-TRY-MOT
Tandem LCF tray-up motor
M42 LCF-ENDF-MOT
Tandem LCF end fence
motor
March 2005 © TOSHIBA TEC
Function
Cooling down the reverse section
(front side)
Cooling down the IH board
Suctioning ozone generated at charging
Cooling down the fuser
Cooling down the exit section
Cooling down the developer unit
Suctioning toner
Cooling down the laser unit
Cooling down the SYS board and hard disk
Cooling down the switching regulator
(rear side)
Cooling down the switching regulator
(lower side)
Driving the read roller for originals
Driving the feed roller, pickup belt and reg-
istration roller for originals
Driving the original lifting tray
Driving the large original exit roller and the
intermediate reverse roller
Driving the small original exit roller and the
small original reverse roller
Lifting up the tray in the tandem LCF
(Only for ASD/ASU/AUD/MJD/CND/KRD
model of all equipments and TWD model of
e-STUDIO850)
Driving the end fence in the tandem LCF
(Only for ASD/ASU/AUD/MJD/CND/KRD
model of all equipments and TWD model of
e-STUDIO850)
e-STUDIO520/600/720/850 OUTLINE OF THE MACHINE
2 - 33
05/07
Remarks P-I
Fig.2-17 15-12
Fig.2-18 24-17
Fig.2-18 33-3
Fig.2-18 33-3
Fig.2-18 33-3
Fig.2-19 42-25
Fig.2-19 42-13
Fig.2-19 32-9
Fig.2-23 54-8
Fig.2-23 52-14
Fig.2-23 52-14
Fig.2-30 83-27
Fig.2-30 86-19
Fig.2-30 86-20
Fig.2-30 87-14
Fig.2-30 87-13
Fig.2-22 31-34
Fig.2-22 9-22
2