Toshiba e-STUDIO520 Service Manual page 245

[H] Drum motor (M11) / Motor driving PC board (MOT)
(1) Take off the rear cover, SYS board and then
hard disk with its bracket.
(2) Remove 3 screws to take off the drum wheel.
(3) Disconnect 1 connector and remove 3
screws to take off the drum motor with its
bracket.
Note:
When installing the drum motor, tighten the
screw while the bracket is pushed against
the motor in the direction of the arrow.
(4) Remove 3 screws to take off the drum motor.
[I] Cleaning brush drive motor (M13) / Drum separation finger solenoid (SOL1)
(1) Take off the exhaust duct.
( P.10-14 "[F] Exhaust duct")
(2) Remove 1 screw and take off the stay.
March 2005 © TOSHIBA TEC
Drum wheel
Screw
Fig.11-24
Drum motor Screw
Screw
Fig.11-25
Fig.11-26
e-STUDIO520/600/720/850 DRUM/CLEANER UNIT
11 - 13
Screw
Connector
Stay
11