Toshiba e-STUDIO520 Service Manual page 110

No. Message
38 Copy size: A4/LT and A4-
R/LT-R
39 CHANGE DRAWER TO
CORRECT PAPER SIZE
40 Change the paper type
41 Select a paper size for
bypass feeding
42 Place the blank sheets in
bypass tray and select the
paper size
43 Place the blank sheets in
the same direction as the
originals
44 Place the same size blank
sheets as the originals
45 Place insertion sheets in
the bypass tray and select
the paper size
46 Select the same size
insert1 sheets as the origi-
nals
47 Select the same size
insert2 sheets as the origi-
nals
48 Set insert1 sheets in the
same direction as the origi-
nals
49 Set insert2 sheets in the
same direction as the origi-
nals
50 READY
(CHANGE THE PAPER
TYPE)
51 Set transparency film in A4/
LT direction
52 CANNOT PUNCH THIS
SIZE PAPER
53 Remove paper from the fin-
isher
54 Cannot staple this size
55 Remove paper from the fin-
isher
56 Examine stapler
57 Check staple cartridge
58 Job interrupted job 1 saved Interrupt copying is accepted
59 Ready to resume job 1
e-STUDIO520/600/720/850 CONTROL PANEL
State of equipment
Displayed when the paper size which
is not specified for "Rotate Sort"
Displayed when the selected paper
size is not in the drawer
Displayed when the selected media
type is not in the drawer
Displayed when paper size needs to
be specified for bypass feeding such
as duplex copying
Displayed when no paper is in the
selected feeder at Cover Sheet
Copying Mode
Displayed when the direction of
cover page is different from that of
other pages at Cover Copying Mode
Displayed when the paper size of
cover page is different from that of
other pages at Cover Copying Mode
Displayed when no insertion sheet is
in the selected drawer at Sheet Inser-
tion Mode
Displayed when the size of insertion
sheet (sheet 1) is different from that
of other pages at Sheet Insertion
Mode
Displayed when the size of insertion
sheet (sheet 2) is different from that
of other pages at Sheet Insertion
Mode
Displayed when the direction of
insertion sheet (sheet 1) is different
from that of other pages at Sheet
Insertion Mode
Displayed when the direction of
insertion sheet (sheet 2) is different
from that of other pages at Sheet
Insertion Mode
Displays when the printing is stopped
because of media type mismatch
Displayed when the selected paper
size is other than A4/LT at OHP
mode
Displayed when the selected paper
size is not specified for hole punching
Displayed when the paper sizes are
mixed at Staple Sorting Mode
Displayed when the paper size is not
specified for stapling at Staple Sort-
ing Mode
Finisher is full of papers
Trouble in the stapler unit in finisher
No stapler in finisher section
Interrupt copying is cancelled (fin-
ished)
5 - 6
Note
March 2005 © TOSHIBA TEC