Toshiba e-STUDIO520 Service Manual page 313

(4) Open 2 clamps and remove 2 connectors.
(5) Remove 2 screws and take off the bracket.
Note:
When installing the bracket, be sure that the
harnesses are not caught.
(6) Pull out the IH coil.
Note:
When installing the IH coil, be sure that the
marks "C" and "S" of the power supply har-
nesses come at the left side.
[E] Upper separation finger unit / Upper separation finger
(1) Take off the fuser unit
( P.14-18 "[B] Fuser unit").
(2) Take off the cleaning web unit
( P.14-19 "[C] Cleaning web unit / Clean-
ing web").
(3) Remove 2 screws to take off the fuser unit
front cover.
(4) Remove 2 stepped screws. Then take off the
upper separation finger unit and a crank
bracket by sliding them to the rear side.
March 2005 © TOSHIBA TEC
Clamp
Connector
Fig.14-24
C ( Blue )
S ( Red )
Fig.14-25
Screw Upper separation finger unit
Crank plate
Fig.14-26
e-STUDIO520/600/720/850 FUSER UNIT
14 - 23
Bracket Screw
IH coil
Black
Screw
14