Toshiba e-STUDIO520 Service Manual page 229

[D] Drum surface potential sensor (S13)
(1) Take off the cleaner unit.
( P.11-7 "[A] Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw,
and then take off the sensor bracket.
(3) Disconnect 1 connector, remove 1 screw,
and then take off the surface potential sensor
(detection section).
(4) Disconnect 1 connector, release 4 lock sup-
ports, and then take off the surface potential
sensor (board section).
Note:
The drum surface potential sensor consists
of the detection section and the board sec-
tion as a set.
March 2005 © TOSHIBA TEC
Sensor braket
Fig.10-18
Connector
Drum surface potential sensor ( board section )
Fig.10-19
Drum surface potential sensor
( detection section )
Locking support
Fig.10-20
e-STUDIO520/600/720/850 PROCESS RELATED SECTION
10 - 13
Screw
Screw
Locking support
10