Toshiba e-STUDIO520 Service Manual page 112

No. Message
77 Please try again after a
while
78 Press START button to
copy after changing setting
79 The number of builds
exceeds the limits will you
copy stored originals?
80 The number of builds
exceeds the limits will you
save stored originals?
81 This setting cannot be
changed now
82 Service recommended for
SPC
83 Service recommended for
IQC
84 (Messages 82 and 83
above appear alternately.)
e-STUDIO520/600/720/850 CONTROL PANEL
State of equipment
Displayed when the Department
Code can no be keyed in immedi-
ately after power-ON
Displayed when the build job is set
Displayed when the number of builds
exceeds the limits
Displayed when the number of builds
exceeds the limits
Displayed when the setting is
changed during the build job is dis-
continued
Displayed when the surface poten-
tial control error occurs
Displayed when the image quality
control error occurs
Displayed when the surface poten-
tial control error and the image qual-
ity control error occur
5 - 8
05/04
Note
Leave it for a while and key in the
code again
Select either printing or canceling
Select either printing or saving
Refer to chapter 5.1.16.
/Service Handbook.
Refer to chapter 5.1.15.
/Service Handbook.
Refer to chapter 5.1.15 and 5.1.16.
/Service Handbook.
March 2005 © TOSHIBA TEC