Toshiba e-STUDIO520 Service Manual page 111

No. Message
60 Cannot use AMS mode
61 More than 200% is not
available
62 Updated the template set-
ting
63 Enter Department Code
64 Cannot copy
Check DEPARTMENT
COUNTER
65 Select the same sized Tab
sheets as the originals
66 Select the same sized
Inserter sheets as the origi-
nals
67 Set Tab sheets in the same
direction as the originals
68 Set Inserter sheets in the
same direction as the origi-
nals
69 Only one paper source can
be used with Cover Sheet
feature
70 Only two paper sources
can be used with Sheet
Insertion feature
71 ADD PAPER TO
INSERTER FEEDER
72 Set the paper source for
Tab sheet
73 Fuser cleaning web
decreased
74 Time for periodic mainte-
nance
(Fuser cleaning web)
75 Tab size: A4/LT only
76 Time for periodic mainte-
nance
March 2005 © TOSHIBA TEC
State of equipment
Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
Displayed when the template stored
is recalled by pressing [TEMPLATE]
button
Displayed when a button is pressed
while the department management
setting is available
Displayed when the number of print-
outs exceeds the limit number of
department counter
Displayed when the paper sizes for
the tab sheets and originals are dif-
ferent
Displayed when the paper sizes for
inserter paper and original are differ-
ent
Displayed when the paper directions
for tab paper and original are differ-
ent
Displayed when the paper directions
for inserter paper and original are dif-
ferent
Displayed when both the cover sheet
mode and inserter cover sheet mode
are selected
Displayed when all the sheet inser-
tion mode, tab insertion mode and
inserter sheet insertion mode are
selected
Displayed when the inserter mode is
valid and the [START] button is
pressed without papers on the tray
Displayed when the tab paper mode
is valid and the tab drawer is not
selected
Displayed when the fuser unit clean-
ing web gets decreased
* This message is set not to be dis-
played at shipment, but the set-
ting can be changed at the setting
mode (08-941).
Displayed when the fuser unit clean-
ing web gets run out
Displayed when the tab paper mode
is valid and other than A4/LT is
selected for the tab paper size
PM cycle
• Displayed at the time for mainte-
nance
• Copying is available
5 - 7
Note
Set the reproduction ratio 200% or
below manually
Set the reproduction ratio 200% or
below
Select the same size for tab sheets
and originals.
Select the same size for the inserter
sheets and originals.
Set the tab sheets in the same direc-
tion as the originals.
Set the inserter sheets in the same
direction as the originals.
Release either the cover sheet mode
or inserter cover sheet mode.
Release any of three modes
• Release the inserter mode
• Set papers on the inserter tray
Select the 2nd drawer property to the
tab to release this state.
Replace the cleaning web.
Replace the cleaning web.
Select A4 or LT for tab paper.
Maintenance and inspection are per-
formed by qualified service techni-
cian
e-STUDIO520/600/720/850 CONTROL PANEL
5