Toshiba e-STUDIO520 Service Manual page 201

(3) Remove 2 E-rings to pull out the transport
rollers from the shaft.
[B-4] Intermediate transport sensor (S17)
(1) Disconnect 1 connector.
(2) Take off the sensor while the sensor arm is
pushed downward (the shield plate is pushed
upward).
Note:
When installing the sensor, make sure the
sensor arm moves properly.
[C] Bypass feed unit
(1) Take off the bypass feed unit.
( P.9-20 "[A] Paper feeder unit / Bypass
feed unit")
March 2005 © TOSHIBA TEC
Transport roller
Fig.9-33
Intermediate transport sensor
Sensor arm
Fig.9-34
e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM
9 - 27
05/07
9