Toshiba e-STUDIO520 Service Manual page 336

[K] Exit motor [M18]
(1) Take off the reverse section driving unit
( P.15-14 "[H] Reverse section driving unit
/ Reverse motor driving PC board (MOT2-RV
board)").
(2) Take off the rear cover
( P.2-47 "[L] Rear cover").
(3) Take off the LGC board cover and disconnect
1 connector.
(4) Remove 2 screws and take off the exit motor.
[L] O-ring
When installing the receiving tray, add the O-rings (service parts) to the exit roller in order to improve
the paper stacking condition.
(1) Remove 6 screws and take off the left lower
cover (exit cover). (
cover (Exit cover)")
(2) Remove 2 E-rings and move the 2 bearings
toward the inside.
(3) Move the exit roller to the near side and
install 2 O-rings to the grooves of the exit
roller.
Note:
O-ring: Refer to the parts list for the parts
number and so on.
e-STUDIO520/600/720/850 EXIT/REVERSE SECTION
P.2-46 "[J] Left lower
15 - 16
05/07
Exit motor
Fig.15-23
E-ring Bearing
Fig.15-24
O-ring
Fig.15-25
March 2005 © TOSHIBA TEC