Toshiba e-STUDIO520 Service Manual page 366
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO520:
- Service handbook (650 pages) ,
- User functions manual (202 pages) ,
- Network administration manual (124 pages)
Table of Contents
Advertisement
10)Start of 2nd original top side scanning
Scanning begins after receiving the original transport signal from the engine. At the same time the
original stop signal is reset. When the read motor (M36) starts to rotate forward, the document feed
motor (M37) also starts to rotate in reverse. (The large original exit solenoid (SOL5) has been ON
from 1st original.)
The SCN-STR turns ON when the leading edge of the original has reached the scanning section.
The large original exit motor (M39) starts to rotate in reverse when the leading edge of the original
has been transported to the large original exit side and come to the 3rd roller.
When the original registration sensor (S55) has detected the trailing edge of the original, the docu-
ment feed motor (M37) stops rotating and the tray lift motor (M38) starts to rotate to lift the tray. The
tray lift motor (M38) stops rotating when a specified number of counts is counter after the lifting tray
upper limit detection sensor (S59) has detected the top side of the original.
The original empty sensor (S60) detects whether or not there is a next original when a specified time
passes after the registration sensor (S55) has detected the trailing edge of the original. If not, the
tray lift motor (M38) starts to rotate to lower the tray and the original set signal is reset. The tray lift
motor (M38) stops rotating when the lifting tray lower limit detection sensor (S62) has detected the
tray.
When the trailing edge of the original has passed the scanning section, the SCN-STR turns OFF
and both the read and large original exit motors (M36, M39) start to accelerate.
The large original exit motor (M39) slows down when the trailing edge of the original has passed the
4th roller and proceeded a specified distance. After the large original exit sensor (S68) has detected
the trailing edge of the original, the read motor (M36) stops rotating soon and the large original exit
motor (M39) stops rotating when the original has proceeded a specified distance. Then the original
is nipped by the large original exit roller.
11)Start of 2nd original back side registering
Same operation as 16.5.2. 6)
e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
Fig.16-55
Fig.16-56
16 - 30
March 2005 © TOSHIBA TEC
Advertisement
Table of Contents
