Toshiba e-STUDIO520 Service Manual page 230

[E] Temperature/humidity sensor (S7)
(1) Take off the control panel unit.
( P.5-17 "[A] Control panel unit")
(2) Disconnect 1 connector, remove 1 screw,
and then take off the temperature/humidity
sensor.
[F] Exhaust duct
(1) Take off the wire cleaner drive unit.
( P.10-11 "[B] Wire cleaner drive unit /
Wire cleaner drive motor (M12)")
(2) Pull out the transfer/transport unit.
(3) Take off the left upper cover.
( P.2-46 "[I] Left upper cover")
(4) Open the left lower cover (exit cover).
(5) Disconnect 3 connectors and release the
harness from 4 clamps.
(6) Remove 1 screw, slide the exhaust duct to
the front side to release the hook, and then
pull it out toward you.
[G] Duct out fan (M27) / Exit section cooling fan (M29)
(1) Take off the exhaust duct.
( P.10-14 "[F] Exhaust duct")
(2) Disconnect 1 connector and pull out the duct
out fan.
(3) Disconnect 1 connector, remove 2 screws,
and then take off the exit section cooling fan
with the bracket.
(4) Remove 2 screws and take off the exit sec-
tion cooling fan from the bracket.
e-STUDIO520/600/720/850 PROCESS RELATED SECTION
Screw
Connector
Duct out fan
10 - 14
Temperature/humidity sensor
Fig.10-21
Clamp Connector
Screw
Exhoust duct
Fig.10-22
Exit section cooling fan
Fig.10-23
March 2005 © TOSHIBA TEC