Toshiba e-STUDIO520 Service Manual page 334

[G] Exit roller
(1) Take off the exit/reverse unit
( P.15-11 "[A] Exit/Reverse unit").
(2) Remove the E-ring, gear and pin.
(3) Remove 2 E-rings and take off the exit roller
by sliding 2 bearings to the inside.
[H] Reverse section driving unit / Reverse motor driving PC board (MOT2-RV board)
(1) Take off the exit/reverse unit
( P.15-11 "[A] Exit/Reverse unit").
(2) Disconnect 1 connector, remove 6 screws
and then take off the reverse section driving
unit.
(3) Release 4 locking supports to take off the
MOT2-RV board.
e-STUDIO520/600/720/850 EXIT/REVERSE SECTION
Exit roller
Pin
Gear
Reverse section driving unit
Reverse motor driving PC board
15 - 14
Fig.15-17
Fig.15-18
Fig.15-19
March 2005 © TOSHIBA TEC