Names And Functions; Optional Controller (Remote Controller) - Panasonic S-36PU1E5A Technical Data & Service Manual

Optional Controller (Remote Controller)

Wireless Remote Controller CZ-RWSU2 / CZ-RWST2 / CZ-RWSL2
One remote control can control a group of up to eight indoor units.

8-1. Names and Functions

REMOTE CONTROL
Displays the operation status.
1. Operation Display
(The figure shows all the statuses.)
2. Start/Stop Pressing this button once starts and
button pressing again stops the operation.
3. Fan speed
button
4. Swing/Wind
Direction button
5. Timer setting Use for operating with a timer.
button
Use this button after changing the
6. Reset button
batteries.
Press at the top center and then
7. Cover
slide down.
8. Transmitter
Detects the temperature at the
9. Remote control
sensor remote controller when detection
has been switched to the remote
control by the sensor button.
10. Temperature
setting buttons
CZ-RWSC2
11. Filter button
Press to turn off the filter lamp on
the receiver.
12. Mode Select Press to switch the operation mode.
button
Use this when connected to an
13. Ventilation
button aftermarket fan. Pressing this button
starts and stops the fan. When the
air conditioner is started or stopped,
the fan starts or stops at the same
time. (
the remote control when the fan is
operating.)
14. Address
button
/ CZ-RWSC2 / CZ-RWSY2 / CZ-RWSK2 / CZ-RWST3
The auto-flap display may be different,
depending on the installed unit.
raises the temperature setting
1 at a time.
lowers the temperature setting
1 at a time.
appears on the display of
15. Sensor button
16. Clock button
1
2
3
4
5
6
7
From this page on the names of remote control
buttons will be abbreviated as the illustration of
the "button".
E.g.: Start/Stop button
8-3
Use this when switching to detect
the temperature at the remote
control. At shipping the default
setting is set to detect the
temperature at the unit. At this time
is shown on the display.
Use this when setting the clock.
8
9
10
11
12
13
14
15
16
8