Panasonic S-36PU1E5A Technical Data & Service Manual page 654

8-20. CZ-RWST3
1. Accessories
No.
1 Receiver
2 Remote Control
3 Remote Control Holder
2. Installing the Receiver
Ceiling Suspended Model
(1) Remove the screw, and slide the latch to open the air-intake grille. (Fig. 8-36)
(2) Insert a flat-head screwdriver from the side, and remove the cover while pressing down on the two cover tabs. (Fig. 8-37)
(3) Route the remote control wiring through the panel, and mount the receiver into the panel holes. (Fig. 8-38)
(4) Route the remote control wiring through the adjustable clamper, and draw in the wire from the remote control wiring inlet
to the inside of the indoor unit. (Fig. 8-38) (See Fig. 8-39 for how to loosen the adjustable clamper.)
(5) Route the remote control wiring through the three saddles, and draw the wire into the electrical box. (Fig. 8-39)
* Draw in the power wire and remote control wiring separately.
(6) Connect the remote control wiring to the terminal board, route through the cable tie (accessory) to the holding clamp,
and secure the remote control wiring. (Fig. 8-40)
(7) Mount the side cover, and close the air-intake grille.
Slide
Latch
Screw
8
Panel
Mounting the Receiver
1 Catch onto the tab
Accessories
Air-intake grille
Fig. 8-36
Adjustable clamper
Remote control wiring inlet
2 Press in the receiver
Fig. 8-38
Quantity No.
4 Dry-cell Batteries
1
5 Users Manual
Truss Self-Tapping Screws
1 6
4 × 16
1 7 Cable tie
Cover
Loosening the
adjustable clamper
Stopper
Loosen the clamper while
pressing the stopper.
Cable tie
(accessory)
Holding clamp
Remote control
wiring
8-30
Accessories Quantity
Cover tabs
Fig. 8-37
Electrical box
Saddle
Fig. 8-39
Fig. 8-40
2
1
2
1