Panasonic S-36PU1E5A Technical Data & Service Manual page 341

(4) Setting the Flap Separately (When setting the CZ-RTC2)
1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps
operate in the same manner.
Air discharge
port
(adjustment for up-down airflow direction)
<Procedure>
Stop the system before performing these steps.
1
Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
and select the address (unit No.) of the indoor unit
to set. At this time, the fan at the indoor unit begins
operating.
3 " ," unit No. "
group control), item code "
" " are displayed blinking on the remote
controller LCD display.
4 Designate the item code "
Temperature Setting
=91
Flap
, and buttons
button
" (or " " in the case of
," and settings data
" by adjusting the
/ buttons.
Electrical component box
=90
=93
=92
5
Press the timer time
desired setting data.
Flap position
5
* Setting data "
Setting data
When the flap position is set to
is in the cooling or dry mode, the flap position is
moved to and the operation is started. (refer to
3
Fig. 1-27)
NOTE
The flap swings during the operation under "Setting
the Flap Separately".
At this time, the unselected flaps are moved to the
position 1 . (refer to Fig. 1-27)
6 Press the
(The display stops blinking and remains lit, and
setting is completed.)
If you wish to change the selected indoor unit,
follow the step
7 Press the
controller display.
7
1
1-331
/ buttons to select the
1
2
3
4
" (refer to Fig. 1-27)
Flap position during operation
Without separate setting
Swing
Move to position and stay
1
Move to position and stay
2
Move to position and stay
3
Move to position and stay
4
Move to position 5 and stay
or and the unit
4 5
button.
2 .
button to return to normal remote
3
6 5
1
Fig. 1-27
2
4