Panasonic S-36PU1E5A Technical Data & Service Manual page 261

Wiring samples
T2 type
Remote control wiring and inter-unit control wiring inlet port
* Insert the remote control wiring and inter-
unit control wiring into the electrical
component box from the inlet port as
shown in the figure. This is done regardless
of whether the wiring was inserted from the
top, rear, or left side of the main unit.
Functional ground screw (Schedule Timer)
Remote Control Wiring
Clamp Power wiring
Protective ground screw
Use this screw when connecting the shield
for the Inter-unit control wiring to ground.
How to carry out power supply wiring
(1) Wiring connection ports
The power inlet port is located at the rear.
The remote control wiring inlet port is located at the rear
(for use with the wired remote controller).
(2) How to carry out wiring
Insert the power wiring into the indoor unit through the rubber
at the side of the electrical component box.
For wiring connection to the outdoor unit and remote control
wiring, open the elongated hole of the piping cover and pass
the wires through the hole.
NOTE
Be sure to use sealing putty to seal off the opening
to prevent dust.
N1 type
6P terminal board
R2 U1
R1 U2 L
Remote Unit Power
controller suppy
control
line wiring
Shielded
wire
ground
Inter-unit Control Wiring
Power inlet port
Clamp
N
Earth
1-251
K1 type
Functional ground screw (External Electronic
Expansion Valve Kit and Schedule Timer)*
Protective ground screw
Fixture screw for resin cover
Resin cover
R1
L1 L2 N
Inter-unit Control Wiring
Power Supply
Use this screw when connecting the shield
for the Inter-unit control wiring to ground.
* As to functional ground screw and protective ground screw,
remove the fixture screw and resin cover. Then, carry out
earth ground work.
R2
U1 U2
Remote Control Wiring
1