Panasonic S-36PU1E5A Technical Data & Service Manual page 305

Test Run Procedure
Recheck the items to check before the test run.
Check the combination (wiring) of indoor and outdoor units.
YES
Turn ON the indoor
and outdoor power.
(Automatic Address Setting)
Is system "single-type"?
(1 indoor unit is connected
to 1 outdoor unit)
NO
Are multiple outdoor units
used?
YES
(See section "Setting the outdoor unit system addresses"
for K1 Type (for Link Wiring).)
How to Set the Outdoor Unit System Address
Set the outdoor unit system address.
(See section "Basic wiring diagram" and
"Setting the outdoor unit system addresses"
for K1 Type (for Link Wiring).)
How to Set Automatic Address
Set the automatic address
setting from outside unit.
Indicate (mark) the combination number.
Set the indoor unit control unit to "TEST".
Can operation
be started?
YES
Turn the power back ON to the
indoor unit.
(See section "Test Run" for K1 Type.)
1-295
(See section "Items to Check Before
the Test Run" for K1 Type .)
(See section "Basic wiring diagram"
for K1 Type (for Link Wiring).)
NO
Turn ON the indoor
and outdoor power.
(Automatic Address Setting)
(See section "Checking indoor unit addresses"
and "Indicating (marking) the indoor and
outdoor unit combination number" for K1 Type
(for Link Wiring).)
(See section "Checking indoor unit
addresses" for K1 Type (for Link Wiring).)
See section "Table of Self-Diagnostic
Functions and Corrections (K1 Type)"
for K1 Type (for Link Wiring).
Refer to "Table of Self-Diagnostic
NO
Functions" to check the system.
In addition, refer to section "Automatic
Address Setting" for K1 Type (for Link
Wiring) and correct any items that need
to be corrected.
Note: Check the indoor-side drainage.
1