Rx Bind 29P; Range Test 29~30P - GRAUPNER HOT TG/mz-12 Operating Instruction

- Receiv out
Press the direction button to select the receiv out line then press the ENT button to access the
function. The cursor is on the arrow mark then press the ENT button to access the function.
-The default channel assignment-
The default channel assignment appears on the screen.
Channel Output
Press the direction button to select S1~S6 then press the ENT
Throttle S1 Output 1
and the direction buttons to highlight and change to the desired
Output 2
Aileron S2
channel. Press the ESC button to get back to the previous
S3 Output 3
Elevator
screen.
S4
Rudder Output 4
NOTE: If you change S1 to S2, the S2 have the 2 channels of
Output 5
5 Channel S5
output 1 and output 2 so the both servo of output 1 and output 2
6 Channel Output 6
S6
are simultaneously moved when the stick of the S2 is move.
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
- Rx bind
Press the direction button to select rx bind line then the cursor is at the hyphen. Turn on the re-
ceiver then press the ENT button on the receiver for over 3 seconds so that the receiver enter the
binding mode. Press the ENT button of the transmitter, the system will be connected within a few
seconds and the model name of the receiver is displayed on the screen after completing the bind.
press
ENT
TEL VIW
ESC
press
- Range test
Press the direction button to select the range test, the cursor is at the 99sec. Turn on the receiver
ENT
then press the ENT button on the transmitter. With the range test started, the Graupner/SJ logo
TEL VIW
blinks with beep for 99sec. Walk over 50 meters away from the model with controlling the trans-
ESC
mitter sticks constantly and check whether the model is operating normally. You should have total
control of the model with the trainer switch pulled.
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
press
ENT
TEL VIW
ESC
ENT
TEL VIW
ESC
29