Checking Transmission Fluid Level; Checking Hydraulic Oil Tank Level - Kubota RTV-X900 Operator's Manual

A When using an oil of different maker or viscosity from
the previous one, remove all of the old oil.
Never mix 2 different types of oil.
A If oil level is low, do not run engine.
BChecking Transmission Fluid Level
1. Park the vehicle on a level surface.
2. Raise the cargo bed and mount the safety support.
3. Stop the engine.
4. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies within the cross hatched area.
If the level is too low, add new prescribed oil to the
prescribed level at the oil inlet.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
(1) Oil inlet (A) Oil level is acceptable within this range.
(2) Dipstick
A If oil level is low, do not run engine.
BChecking Hydraulic Oil Tank Level
1. Park the vehicle on a level surface.
2. Stop the engine.
3. Open the seat and remove the utility box.
4. Remove the rubber cap.
5. To check the oil level, remove the dipstick, wipe it
clean, screw it into filling hole and remove dipstick
again.
If the level is too low, add new prescribed oil to the
prescribed level at the oil inlet.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
(1) Filling plug with dipstick
A If oil level is low, do not run engine.
PERIODIC SERVICE
(A) Oil level is acceptable within
this range
53