Anti-Freeze - Kubota RTV-X900 Operator's Manual

(1) Drain plug
(2) Front skid plate
(1) Radiator cap
(2) Recovery tank
(1) Engine coolant breather
A Do not start engine without coolant.
A Do not remove the cap on the radiator.
A Use clean, fresh distilled water and anti-freeze to fill
the radiator and recovery tank.
(A) "FULL"
(B) "LOW"
A When the anti-freeze is mixed with distilled water, the
anti-freeze mixing ratio is 50%.
A Securely tighten radiator cap. If the cap is loose or
improperly fitted, water may leak out and the engine
could overheat.
A Make sure that the engine coolant breather is closed,
after filling the coolant.
BAnti-Freeze
To avoid serious injury:
A When using anti-freeze, put on some protection
such as rubber gloves. (Anti-freeze contains
poison.)
A If it is swallowed, seek immediate medical help.
Do NOT make a person throw up unless told to
do so by poison control or a health care
professional. Use standard first aid and CPR
for signs of shock or cardiac arrest. Call your
local Poison Control Center or your local
emergency number for further assistance.
A When anti-freeze comes in contact with the
skin or clothing, wash it off immediately.
A Do not mix different types of Anti-freeze.
The mixture can produce chemical reaction
causing harmful substances.
A Anti-freeze is
explosive under certain conditions. Keep fire
and children away from anti-freeze.
A When draining fluids from the engine, place
some container underneath the engine body.
A Do not pour waste onto the ground, down a
drain, or into any water source.
A Also, observe the relevant environmental
protection regulations when disposing of anti-
freeze.
Always use a 50/50 mix of long-life coolant and clean soft
water in KUBOTA engines.
Consult your local KUBOTA dealer concerning coolant for
extreme conditions.
1. Long-life coolant (hereafter LLC) comes in several
types. Use ethylene glycol (EG) type for this engine.
2. Before employing LLC-mixed cooling water, fill the
radiator with fresh water and empty it again.
Repeat this procedure 2 or 3 times to clean up the
inside.
3. Mixing the LLC
Premix 50% LLC with 50% clean soft water. When
mixing, stir it up well, and then fill into the radiator.
4. The procedure for the mixing of water and anti-freeze
differs according to the make of the anti-freeze and the
ambient temperature. Refer to SAE J1034 standard,
more specifically also to SAE J814c.
PERIODIC SERVICE
extremely flammable
81
and