Replacing Engine Oil Filter; Changing Engine Oil - Kubota RTV-X900 Operator's Manual

BReplacing Engine Oil Filter
To avoid serious injury:
A Be sure to stop the engine before changing the
oil filter.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface.
2. Stop the engine.
3. Remove the rear skid plate.
4. Remove the oil filter.
5. Put a film of clean engine oil on the rubber seal of the
new filter.
6. Tighten the filter quickly until it contacts the mounting
surface.
Tighten the filter by hand an additional 1/2 turn only.
7. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
8. Properly dispose of used filter.
(1) Engine oil filter
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
(A) Battery
BChanging Engine Oil
To avoid serious injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a level surface.
2. Raise the cargo bed and mount the safety support.
3. Stop the engine.
4. Remove the rear skid plate.
5. To drain the used oil, remove the drain plug at the
bottom of the engine and completely drain the oil into
an oil pan.
All the used oil can be drained out easily when the
engine is still warm.
6. After draining, reinstall the drain plug.
7. Fill with the new prescribed oil up to the upper line on
the dipstick.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
8. Properly dispose of used filter.
RTV-X900
Oil capacity
RTV-X1120D
[RTV-X900]
(1) Oil inlet (A) Oil level is acceptable within this range.
(2) Dipstick
PERIODIC SERVICE
[Filter exchanged]
3.1 L (3.3 U.S.qts.)
[Filter non-exchanged]
2.7 L (2.9 U.S.qts.)
[Filter exchanged]
4.1 L (4.3 U.S.qts.)
[Filter non-exchanged]
3.8 L (4.0 U.S.qts.)
69