PARKING
BParking Brake Lever
To avoid serious injury:
BEFORE DISMOUNTING VEHICLE
A ALWAYS SET PARKING BRAKE AND LOWER
ALL IMPLEMENTS TO THE GROUND.
Leaving transmission in gear with the engine
stopped will not prevent vehicle from rolling.
A STOP THE ENGINE AND REMOVE THE KEY.
1. Stop the vehicle on a level surface.
2. To set the parking brake, depress the brake pedal and
pull the parking brake lever to the rear engaged
position.
3. To release the parking brake, depress the brake
pedal, push release button and push up parking brake
lever. Depressing the brake pedal makes release
force smaller. Make sure that indicator in the Easy
Checker(TM) goes off.
(1) Parking brake lever
(2) Release button
A If the vehicle is operated with the parking brake
applied, the brake will be damaged.
(A) "RELEASE"
(B) "PUSH"
OPERATING THE VEHICLE
ACCESSORY
B12V Electric Outlet
The 12 volt power point is located on the front-panel. An
auxiliary light or other devices may be connected to this
outlet.
C This outlet is powered when the key switch is in
either the "ON" or "OFF" position.
Remove accessory when not in use to avoid battery drain
down.
C Do not connect a light or other device that draws
more than 120 watts to this power point, or the
battery may discharge very rapidly or the outlet
may fail.
A Do not use as a cigarette lighter.
A Do not use when wet.
A Make sure that the cap is closed when the outlet is not
used.
(1) 12V electric outlet
BUtility Box
(1) Utility Box
25