Replacing Slow-Blow Fuses; Replacing Light Bulb; Checking Hydraulic Tank Suction Strainer - Kubota RTV-X900 Operator's Manual

BReplacing Slow-Blow Fuses
The slow-blow fuses are intended to protect the electrical
cabling. If any of them have blown out, be sure to pinpoint
the cause. Never use any substitute, use only a KUBOTA
genuine part.
C Replacement procedure
1. Disconnect the negative cable of the battery.
2. Open the seats and remove the utility box and
maintenance cover.
3. Remove the fuse box cover.
4. Pull out the slow-blow fuse.
5. Insert a new slow-blow fuse into the slow-blow fuse
box.
6. Install the slow-blow fuse box cover and the
maintenance cover.
7. Connect the negative battery cable.
BReplacing Light Bulb
1. Head light and turn signal light (front)
Take the bulb out of the light body and replace it with
a new one.
2. Other lights
Detach the lens and replace the bulb.
Light
Head light (Clear type)
Tail light
Brake light
Turn signal light (front)
Turn signal light (rear)
Work light (front)
Work light (rear)
Capacity
37.5 W
5 W
21 W
21 W (if equipped)
21 W (if equipped)
35 W (if equipped)
27 W (if equipped)
BChecking Hydraulic Tank Suction Strainer
1. Make sure that the hydraulic tank is not damaged and
the oil does not leak out of the hydraulic tank.
2. Make sure that the water is not mixed with the oil.
3. When the suction strainer is dirty, wash it with the light
oil.
(1) Hydraulic tank
(2) Suction strainer
PERIODIC SERVICE 85