Replacing Transmission Oil Filter [Vht] - Kubota RTV-X900 Operator's Manual

70 PERIODIC SERVICE
[RTV-X1120D]
(1) Oil inlet (A) Oil level is acceptable within this range.
(2) Dipstick
(1) Rear skid plate
(1) Drain plug
BReplacing Transmission Oil Filter [VHT]
To avoid serious injury:
A Be sure to stop the engine before changing the
oil filter.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface.
2. Remove the rear guard.
3. Remove the oil filter.
4. Put a film of clean transmission oil on the rubber seal
of the new filter.
5. Quickly tighten the filter by hand until it contacts the
mounting surface, then, with a filter wrench, tighten it
an additional 1/2 turn only.
6. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
7. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
8. Make sure that the transmission fluid doesn't leak past
the seal on the filters.
(1) Transmission oil filter (VHT) (Yellow color)
(2) Rear guard
A To prevent serious damage to the transmission, use
only a KUBOTA genuine filter.