Changing Front Axle Case Oil - Kubota RTV-X900 Operator's Manual

(1) Drain plug
(2) Magnet plug
C Cleaning Magnet Plug
Remove the magnet plug and clean off metal filings.
A Do not operate the vehicle immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
BChanging Front Axle Case Oil
1. Park the vehicle on a level surface.
2. Turn over the rubber sheet.
3. To drain the used oil, remove the drain plug and the
filling plug at the front axle case and drain the oil
completely into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with the new prescribed oil up to the upper line on
the dipstick.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
6. After filling, reinstall the filling plug.
7. Properly dispose of used oil.
Oil capacity
(1) Drain plug
(2) Filling plug with dipstick
PERIODIC SERVICE
0.6 L (0.6 U.S.qts.)
(A) Oil level is acceptable
within this range
79