Rear Axle Bracket - Kubota RTV 900 Workshop Manual

RTV900, WSM

Rear Axle Bracket

1. Remove the boot band (2) on both sides.
2. Place the stand under the both side of frame.
3. Remove the rear wheels.
4. Remove the leaf spring mounting bolt (1) and nut, and remove
the rear axle bracket assembly (3) by use the axle support (4).
(When reassembling)
• Align the master spline of propeller shaft and rear axle shaft.
• Replace the boot band with new one.
Leaf spring mounting bolt
and nut
Tightening torque
Rear wheel mounting
screw
(1) Leaf Spring Mounting Bolt
(2) Boot Band
9-S7
NEW TRANSMISSION
48.0 to 56.6 N·m
4.9 to 5.7 kgf·m
35.4 to 41.3 ft-lbs
75.0 to 90.0 N·m
7.6 to 9.2 kgf·m
55.3 to 66.4 ft-lbs
(3) Rear Axle Bracket Assembly
(4) Axle Support
W1018767
KiSC issued 04, 2006 A