Replacing The Foot Holder - ELNA eXpressive 860 Instruction Manual

w
q
e
q

Replacing the Foot Holder

Replace the foot holder, if you use the darning foot or
embroidery foot.
CAUTION:
Press the lockout key to lockout the machine or turn the
power switch off before replacing the foot holder.
Removing the presser foot holder
Raise the needle by pressing the needle up/down button.
Press the lockout key and raise the presser foot with the
presser foot lifter.
q Lockout key
w Presser foot lifter
Loosen the thumbscrew and remove the presser foot
holder.
e Thumbscrew
Attaching the darning foot PD-H
Attach the darning foot PD-H to the presser bar by putting
the pin on the needle clamp screw.
w
q Pin
w Needle clamp screw
Tighten the thumbscrew firmly with the screwdriver.
Attaching the embroidery foot P
Attach the embroidery foot P to the presser bar from
behind.
Tighten the thumbscrew firmly with the screwdriver.
19