Configuring Dial-Up Over Ppp With Modems Or Tas; Scenario 1: Single Destination Per Port - 3Com NETBuilder SI Using Manual

86 C 7: A
HAPTER DVANCED
Configuring Dial-Up
over PPP with
Modems or TAs
ISDN TAs
Model 44x
!6
!5 (path)
!5
!4 (path)
TA
128 K
TA
1-408-555-7000
C P
ONFIGURATION OF ORTS AND
This section describes two dial-up scenarios:

Scenario 1: Single Destination per Port

Scenario 2: Multiple Destinations
If you are using both B channels together for a 128 Kbps connection,
each TA used at each end of the connection must support the same B
channel aggregation protocol: Multilink PPP or bonding.
You cannot use each B channel independently on an external ISDN TA.
Scenario 1: Single Destination per Port
This scenario shows a model 44x bridge/router connecting to one
destination on each serial port.
28.8 K
Modem
Each Serial port connects to
one destination.
Start here
Set the normal bandwidth for ports 5 and 6:
SETDefault !5 -PORT NORMalBandwidth = 128
SETDefault !6 -PORT NORMalBandwidth = 28.8
Syntax: SETDefault !<port> -PORT NORMalBandwidth = <kbps> (>=0)
Create the dial number list for ports 5 and 6:
ADD !5 -PORT DialNoList "1-408-555-7000" Baud = 128 Type = Bri
ADD !6 -PORT DialNoList "1-510-555-9876" Baud = 28.8 Type = Modem
Syntax:
ADD !<port> -PORT DialNoList "<phone no>" [Baud = <rate> (1.2–16000)]
[Type = Modem | Bri | Sw56] [Pos = <number>]
Done
P
ATHS
Modem
1-510-555-9876