Using The 56/64 Kbps Csu/Dsu Module Autobaud Feature; Prerequisites; Defaults; Procedure - 3Com NETBuilder SI Using Manual

112 C 9: C
HAPTER USTOMIZING
Using the 56/64
Kbps CSU/DSU
Module Autobaud
Feature

Prerequisites

Defaults

Procedure

Y S
OUR OFTWARE
When you define the name parameter, these error messages may be
returned:
Rejected name - Contains invalid character(s)
Rejected name - Null string not allowed
Rejected name - It is already in use
Rejected name - Must start with alphabetic character
This section describes the autobaud feature, which allows the 56/64
Kbps CSU/DSU module to detect the baud rate automatically.
The two ports of the end bridge/routers must be configured to the same
port owners to allow the data link such as PPP to come up at the correct
baud rate.
The default setting is Autobaud ON.
You can turn off autobaud by setting the baud rate. For example, to set
the baud rate to 64 K, enter:
SETDefault !2 -PAth BAud=64
The autobaud feature is turned off and the CSU/DSU module is set to the
defined baud rate only. This terminates any autobaud that has already
started.
To turn on autobaud by setting the baud rate to auto, by entering:
SETDefault !2 -PAth BAud=AUto
This example sets up a 56/64 Kbps CSU/DSU module to communicate
with the central site NETBuilder router whose baud rate is already
configured.
1 Configure the remote site router to the same identical port owner as the
central site router.
2 To turn the autobaud feature on at the 56/64 Kbps CSU/DSU module,
enter:
SETDefault !2 -PAth BAud=AUto
SETDefault !2 -Path CONTrol=ENAble