Siemens Ewsd Switch; Spids - 3Com NETBuilder SI Using Manual

192 A E: P
PPENDIX ROVISIONING

SPIDs

Y ISDN L
OUR INE

Siemens EWSD Switch

To order ISDN service for a Siemens EWSD switch, provide the phone
company with the information in Table 36.
Table 37 Ordering ISDN Service for a Siemens EWSD Switch
Required Information
Line Type
Line Code
Interface Type
Circuit-switched Option
Bearer Restriction Option
Protocol
SPID suffix
Terminal Endpoint Identifier (TEI)
Ring
Maximum Keys
Key System (EKTS)
Voice or Data
Lower Layer Compatibility Option for Data
When you request services, you may also need the following information
about SPIDs and other service attributes:
Request multipoint, initializing terminal service; the maximum number
of terminals is two. The service provider supplies you with two SPIDs.
If you request ISDN service from an AT&T 5ESS service provider and
the switch is running custom (or non-National ISDN 1) software, the
format is:
01 + 7-digit telephone number + 1-digit suffix.
If you request a different telephone numbers for each B channel, the
suffix can be the same. A suffix of 0 is typical in this case. If you decide
to use the same telephone number for both B channels, use a
different suffix so that the two SPIDs are unique.
If you request NI-1 (National ISDN 1) service from an AT&T 5ESS
service provider, the format is:
01 + 7-digit telephone number + 1-digit suffix + 2-digit TID (terminal
identifier).
Specification
National ISDN 1 line
2B1Q (2B+D)
S/T interface with NT1 (model 43x) or
U interface (model 44x) and RJ-45 jack
Yes
No packet mode data (NOPMD)
PPP
1
Dynamic
No
64
No
Data
B channels