3Com NETBuilder SI Using Manual page 161

Table 20 Online Help Syntax Summary (continued)
Syntax
-<service> ?
<command> -<service> ?
<command> ?
<command> -<service>
<parameter> ?
Description
Displays a list of commands within the selected service.
For example, to display a list of commands in the SYS Service, enter the following
command:
-SYS?
If there are no commands under the service you specify, a message is displayed to
indicate this. For example:
-IDP?
No commands available in IDP service
Displays a list of parameters within the selected service.
For example, to display a list of PORT Service parameters that can be used with the
SETDefault command, enter the following command:
SETDefault -PORT?
Displays the parameters by service name that can be used with the selected
command. Only those parameters in services specified by the CurrentServices
parameter are displayed.
Displays the syntax for a command used with a particular parameter.
For example, to display the syntax for the SETDefault command used with the
CONTrol parameter in the SNMP Service, enter the following command:
SETDefault -SNMP CONTrol?
Getting Help 161