Dip Switches; Hardware Interrupt Switch - 3Com NETBuilder SI Using Manual

20 C 1: F
HAPTER EATURES AND

DIP Switches

Hardware Interrupt
Switch
S
PECIFICATIONS
DIP switches are located on the left side of the bridge/router (when facing
the front panel) and are for 3Com use only.
CAUTION: To avoid accidentally erasing your flash memory or
reinitializing the EEPROM, make sure all switches are in the down
position.
Left side of unit
DIP switches
The hardware interrupt switch is located on the left side of the
bridge/router (when facing the front panel). It is recessed into an opening
near the DIP switches. Press the switch with a nonconductive object, such
as a plastic stylus, to activate the monitor firmware utility.
Left side of unit

Hardware interrupt switch

WARNING: Use only a nonconductive object, such as a plastic stylus, to
press the hardware interrupt switch. Do not use the tip of a pencil.
Graphite particles from the pencil may cause you to receive an electric
shock and may damage components on the motherboard.