Configuring Ridging And; Configuring The Central Node For Boundary Routing; Configuring Transparent Bridging - 3Com NETBuilder SI Using Manual

8
Configuring the
Central Node for
Boundary Routing
Configuring
Transparent
Bridging
C
ONFIGURING
R
OUTING
This chapter provides the following procedures:
Configuring the Central Node for Boundary Routing
Configuring Transparent Bridging
Configuring IP Routing
Configuring IPX Routing
To configure other routing protocols, see Using Enterprise OS Software.
The model 4x7 bridge/router can be used as a central node in a Boundary
Routing environment. SuperStack II NETBuilder SI bridge/routers can be
used as a central node only for Ethernet boundary routers.
The model 5xx bridge/router does not support leaf node Boundary
Routing.
Boundary Routing system architecture treats the remote site as another
central site LAN segment, which allows all routing to occur at the central
site. Boundary routers require very little or no configuration. You must
configure the central site for Boundary Routing by referring to the
following chapters in Using Enterprise OS Software:
"Configuring Boundary Routing System Architecture"
"Configuring Auto Startup"
When transparent bridging is enabled, the bridge forwards packets based
on the destination address in the packets it receives. It also learns and
records information about the location and addresses of devices on the
surrounding networks, based on the source address in the received
packets.
B
RIDGING AND